BV2QS MMDVM BOX

-

 




留言

張貼留言

這個網誌中的熱門文章

Pi-star POCSAG(DAPNET)

-
圖片
1.TO  DAPNET   Apply for an account to send a message Apply for a pocsag id (caller needs to attach your dmr id)    去  DAPNET  申請帳號發訊息用 申請pocsag id (呼叫器用需附上你的dmr id) 2.TO   DAPNET  Apply for a Send password (pi-star)    去  DAPNET  發射密碼給pi-star用 GP2009 info
閱讀完整內容

MMDVM Firmware upgrade guidelines (韌體燒錄方法)

-
圖片
mmdvm hs duplex Firmware update jp1=on sudo pistar-mmdvmhshatflash hs_dual_hat jp1=off https://www.youtube.com/watch?v=fEOM7By4UjU ***************************************************************************************************************** Firmware upgrade for Orange pi PI-STAR  (EA7GIB PCB ) Welding a line Orange pi GPIO PA03 to Stm32F103c8t6 RESET  Orange pi GPIO PA03 Stm32F103c8t6 RESET  Switch BOOT=0  TO  BOOT=1 Open your pi-star dashboard in a web browser - Go to SSH-Access http://pi-star/admin/expert/edit_mmdvmhost.php - Login (user pi-star + your password) - Type "sudo pistar-nanohsflash nano_hs - press any key to confirm (last time by pressing CTRL-C to exit) - Wait until you receive the message that the flashing is complete, then press any key to restart - complete also try Sudo pistar-update Sudo pistar-upgrade https://youtu.be/w-0C1saYOFg Precautions  Switch BOOT=0 TO BOOT=1 After the upgrade,
閱讀完整內容

IC-9700 DV GW (Terminal Mode / Access point Mode)

-
圖片
Terminal  Mode  (use lan) IC-9700 SETUP 1.IC-9700用網路線連接網路或分享器    IC-9700 uses a network cable to connect to a network or sharer 2.Gateway Select  ==>Internal Gateway(LAN) 3.MENU==>DV GW=>Internal Gateway (輸入反射器的網址  or IP) 4.  MENU==>DV GW==>  <<Terminal Mode>>      (啟動 Terminal 模式) 5.DR 模式  在TO的地方要設定 /XLX886C       (輸入想要連線得模組)   按TO =>DIRECT I(RPT)=>輸入/XLX886C Access point Mode (use lan) 1.IC-9700用網路線連接網路或分享器 2.分享器 開PRORT給IC-9700用 Port:40000 3.Ic-9700 SETUP  .Gateway Select  ==>Internal Gateway(LAN)  MENU==>DV GW=>Internal Gateway      (輸入反射器的網址 or IP) 4.啟動Access point Mode     MENU=>DV GW=>Access point Mode Adding a D-Star Hotspot on the IC-9700 ID-5100 SETUP 1.Menu>DV Memory設定中繼台 2.設定好了之後  進去DR模式  TO點進去 3.選 DIRECT INPUT(RPT) 設你要連線的反射器(例如 XLX886CL) XL反射器版本2.4.0以上才有支援
閱讀完整內容